Bryce 9K-L Especificações descarregar pdf (Página 27)

Operating the Printer

Recheck your setup and adjustments:

Sliding

Fence

Adjustment

• Is the feed gap set?

• Is the Wire Form in the center of the media?

• Is the Wire Form at a good height?

• Is the Feed Ramp beneath the edge of the media?

Position the Sliding Fence before stacking the bin area with

media. The fence has to be close enough to the media to keep

it from going in at an angle and loose enough for the media to

drop down to the Feed Rollers. To properly position the fence:

1. Place a handful of the prepared media in the input bin

area.

2. Square the stack against the wall of the Rear Support

Plate Assembly and the H-Block Assemblies.

3. Push the Sliding Fence in near the media. Leave a gap

of 1/16 of a inch (1.6 mm) or the thickness of one or

two #10 envelopes. This size of gap places the fence

close enough to prevent pieces from twisting and

turning as they enter the printer and the fence won’t be

too close to the media to trap and restrain the pieces

between the fence and the wall of the Rear Support

Plate Assembly. This would hinder the media from

being fed into the printer.

Revision A 9K-L USERS MANUAL Section 4 -

P/N 90-00860-001

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 150 151

Sem comentários

Bryce 9K-L Especificações Página 27